1 pcs HP 4000/4050 Fuser Film Sleeve with Grease

1 pcs HP 4000/4050 Fuser Film Sleeve with Grease

Quality Fuser Film Sleeves in Durability, Reliability, Longevity
Your 100% Satisfaction Guaranteed

1 pcs HP 4000/4050 Fuser Film Sleeve

Feature:

• Dimention: 228 mm
• Ring length: 4 mm;
• Diameter: 24 mm;
• Meet ISO 9001-2000 standard and follow it’s strictly quality control system.
• This product has been qualified/certified by HP to be used in HP 4000/4050 series
• Please contact us for the quote of large quantity of fuser film sleeves, we are seeking resellers and service centers
• All Fuser Film Sleeve are manufactured from imported materials made in Japan with excellent workmanship and superior formula.The Fuser Film Sleeves are excellent for printing various papers such as copying paper, sulphuric acid paper and name card paper.

How to replace the fuser film sleeves

• Take off the used/damaged fuser film sleeve from the fixing film assembly or fuser.
• By preparing the assembly remove all grease remaining from the previous sleeve installation. Remove also the old grease from the end caps. Clean surface of heating element by using a Q-tip with alcohol.
• Now apply grease to about 15-20 places on the surface of the ceramic heating element and on the side of the holders/fixtures. It proofed sufficient to spread it evenly over the surface with a wooden spatula.
  Total amount of grease to apply is around 1 gram for Letter/A4, and 2.0 grams for A3 (wide) paper printer. Make sure no grease is applied to the surface of the film sleeve.
• When removing the replacement film from its packaging take care. D'ont pinch or fold it.
• While slipping the replacement film over the heating element core avoid all sharp edges that the replacement film may encounter. Turn the film a few rounds to make sure the grease is spread evenly on the inner surface of the replacement film. When you feel film turning is free, you can continue to assemble. Make sure no grease is applied to the surface of the film sleeve.
• Position the film into heater. Make sure that the end with grounding ring of the film sleeve positions to the same end where in the fuser the grounding conductor is located. The end of the film with ground ring should be in good contact with the conductive rubber gear of pressure roller or the conductive brush after installation.
• After the fuser assembly is reassembled, be sure to push both end caps inwards towards the center

Warranty and Return:

Products are come with 90 days quality warranty. Warranty is limited to the value of the merchandise, does not cover any consequential or incidental damages incurred. Return within 30 days; must be in original condition for refund. 20% restocking fee will be applied. Shipping and handling charges are not refundable.